MATERIAL SAFETY DATA SHEET
Essentially Similar to
Revised: 01/20/2012
HMIS Health-1 Flammibility-3 Reactivity 0
SECTION I-Product Information
Manufacturer: AVW,
Inc.
24 Hour Emergency
Phone Number: 800-424-9300
Product Name: Carb & Choke Cleaner
SECTION II-Hazardous Ingredients
Xylene CAS# 95-47-6 TWA 100 % 25-30
Methanol CAS# 67-56-1 TWA 200 0.1- 3
Mineral Spirit CAS# 8052-41-3 TWA 200 5-10
Acetone CAS# 67-64-1 TWA 1000 1-5
Isopropanol CAS# 6763-0 TWA 400 25-30
Propane CAS# 74-98-6 TWA 1000 18-23
Butane CAS# 106-97-8 TWA 800 12-17
Boiling Point: 188 F
Specific Gravity (H20=1)=.86
Solubility in Water: .0%
Appearance: Colorless liquid with penetrating ether like odor.
Flash Point: 98 F Extremely Flammable Level 3 Aerosol
Extinguishing Media: Water, CO2, Foam, And Dry Chemical
Special Fire Fighting Procedures: Do not expose containers to temperatures above 120 F.
Unusual Fire and Explosion: Forms flammable vapor air mixtures. Lower temperatures increase the difficulty of getting it to ignite.
Time Weighted Average (TWA): 100 ppm based in the raw material.
Carcinogen: No
Acute Chronic Health Effects: Excessive exposure may cause irritation to upper respiratory tract. Excessive exposure may cause carboxyhemoglobinemia, thereby impairing the bloods ability to transport oxygen.
Primary Routes of Entry: X Inhalation X Skin X Ingestion
Effects of Overexposure: Eyes- May cause pain, moderate eye irritation and slight corneal injury. Vapors may irritate eyes.
Skin- May cause irritation. Repeated contact may cause drying or flaking of the skin.
Inhalation- In confined or poorly ventilated areas, vapors can readily accumulate and cause unconsciousness and death.
Ingestion- May be harmful.
First Aid:
Eyes- Flush with water for 15 minutes. If irritation persists get medical attention.
Inhalation- Move to fresh air. Get medical attention.
Ingestion- Do not induce vomiting. Get medical attention immediately.
Stability: Stable X
Conditions to Avoid: Hydrolysis producing small amounts of hydrochloric acid possible with gross water contamination. Avoid open flames, welding arcs, or other high temperature sources, which induce thermal decomposition.
Incompatibility: Strong oxidizers; caustics, chemically active metals such as aluminum, magnesium and sodium.
Steps to take in case material is spilled or released: Use absorbent material and trash receptacle. Waste disposal method Federal and Local regulations.
Respiratory Protection: Adequate ventilation
Gloves (type): Chemical resistant
Eye Protection: Glasses (if required)
Other Protective Equipment: None
Precautions to be taken in handling and storing: Read and follow all label directions. Do not store containers at temperatures above 120 F.